Float

Specifications:

• The basic materials of our floats are NBR and phenolic resin,through two steps molding process, precure and finalcure.

Description:

The basic materials of our floats are NBR and phenolic resin,through two steps molding process, molded hole, internal structureis a closed-cell, homogeneous structure, and outside layers is ahard, smooth outer surface This can protect the cell structure andadds to the mechanical strength of the part


1) Product Specification:
● Our floats is a closed-cell material, Unlike hollow floats, theyare not subject to sudden failure Being able to resist most fuels,oils, aqueous solutions, solvents, and chemicals. 
● Special to methanol and fuel mixtures.
● Using molded hole technology, better than drilled hole.
● Can mold floats into complex shapes per customer requirement.
● Being able to design different density range floats per customerrequirementRing magnets and metal or plastic inserts can be moldedin for accurate level sensing.
● Low sulfur releasing (<5 ppm), not damage silver platingsender cards.
2) Density:NBR floats are available in two general densityranges;
●* 160~190kg/m3(10-12lbs/ft3) 
●* 285~320kg/m3(18-20lbs/ft3)Special density range can be met bycustom molding. 
3) Operation Temperature:
● Our floats are recommended to use from -60°C to +120°C.By specialprocessing, floats can be post cured to operate in a 150°Cenvironment.
4) Operation Pressure:
● Our floats can resist pressure up to 2MPa or higher, Dependingon: shape and size of the float, density, operating temperature,and the fluid in which it is used

Float